Castle Wedding Pop up card

Assembly instructions

Purchase this design here

This is what you will see on your digi mat

On each of the layers there is a folding glue tab

These fold backwards and they slot through the v shaped cut lines on the upper base section. 

The castle is the back layer, the one with the bride and groom in the centre is the middle layer and the other one with the car is the front layer

Slot each one through it's slot on the upper base and glue in place underneath folding the glue tab backwards

Do this with all 3 layers

Leave a couple of minutes to dry then apply glue to the underneath of the upper base section and position in in the center of the main base lining up the center fold line. press down firmly around all the base and leave to dry before folding

The card is now finished, fold when completely dry