Party or Gift Crackers and box

Assembly instructions

Purchase this file here

 Your digi mat will look like this for your crackers

Cut all the pieces ( make 6 of these to go in the box)

Fold the thin section inwards and the 2 fold lines either side of that fold the opposite way.

Open it back out and roll it over a table edge to help it curve to make it easier to join the ends

use sticky tape on the glue tabs and curve the cracker so that the ends meet and press together to make sure it sticks well

Now add your decorative pieces i your colour choice and the  put in your candy or gifts and then tie some ribbon or string around the thin section of each end of the crackers to stop anything falling out

This is how the Box looks on your digi mat

Make the bottom first

The 4 oblong pieces are the sides. 

Glue them in place

You can cut 2 bases to add strength if you wish  and glue the other one inside to hide the glue tabs, this will also make the box look neat.

Now the lid

Glue the acetate to the front frame on the outside then glue the sides in place but put the glue tabs on the outside so that when you add your decorative piece it will hide the acetate abd the glue tabs making the inside of the lid nice and neat

once the lid is built add the decorative pieces in your colour choices

Now pop in the crackers you have made into the box they will fit nicely

and put the lid on :)

Dimensions

Crackers as cut

7" x 4.75"

Box

9" x 6.5" x 1.75"

These crackers can be used for parties, but also they would be super as a little gift for someone, if you put some candy or beauty products etc in the crackers it will make a fabulous gift and also unusual